The course of multilines can be changed in sections and bundled.

Procedure

Multilines

1.Call function
The function can be opened via Toolbar > Edit > Multilines. In the left side panel, the Multilines tab opens.

2.Define Section
To change multilines in the Edit section, click on the
Define Section button. The mouse pointer switches to edit mode and a section can now be drawn over affected line features whose course is to be changed.

3.Create new axis
Click the Change course button to switch the mouse pointer to edit mode so that a new axis can be created in the area of the previously selected section.

4.Select affected features
In the Selected features section, features that are included in the defined section can be excluded from the change using the minus button.

5.Set gap between lines
In the View settings section, you can specify the gap between the lines at which the changes are to be made.

6.Finish editing
Editing can either be successfully completed using the Save edits button or exited without making any changes by clicking Cancel.

 

Please note that the repositioned line must end on the same feature. It is also necessary for the line to start and end at a point where the feature intersects the boundary of the selected area (these intersection points can also be the start and end points of the feature). This also means that the feature must not end in the section marked for the change.